Battery Current Sensor: Installation

INSTALL BATTERY CURRENT SENSOR
1. Insert the hook of the ground terminal through the battery current sensor's hole. Then attach the hook to the parts labeled A of the bracket.
  
  Fig 1: Inserting Hook Of Ground Terminal Through Battery Current Sensor's Hole
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Hook the bracket onto the hole on the engine room body, and install the battery current sensor assembly with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Locating Terminal Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector to the battery current sensor assembly.
INSTALL FRONT FENDER PROTECTOR UPPER RH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL COWL TOP VENTILATOR LOUVER RH (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.