Wiper Motor

Download the full database via torrent (~1.1 TB)

Remove wiper motor from vehicle. Connect jumper wires to connector at motor to check both speeds. For low speed, connect battery voltage to Blue wire terminal and ground the Blue/White terminal. For high speed, ground the Blue/Red terminal instead.

To check the park switch, apply battery voltage to the Blue wire terminal. Connect a jumper wire between Blue/White and Blue/Black. Ground the Black wire. Motor should run briefly and stop.

MAZDA INTERMITTENT WIPER RELAY LOCATIONS

Model

Connector

Location

GLC

Hatchback

6-pin

Left of instrument cluster

Wagon

6-pin

Right rear of engine comp.

B2000 & B2200

4-pin

Left of instrument cluster

RX7 ⁽¹⁾

17-pin

Left kick panel

626

6-pin (4 wires)

Left kick panel, top front relay

⁽¹⁾	Time delay is controlled by "Control Processing Unit".

To check rear wiper motor, apply battery voltage to Blue/Red wire and ground the Blue/White wire. Motor should run steadily.