Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Mazda >> 1984 >> B2000 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Evaporation System >> Component Testing >> Check & Cut Valve >> GLC

Check & Cut Valve: GLC

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Remove check and cut valve from lines. Connect a pressure gauge with "T" on nipple leading to fuel tank. Hold finger over opposite nipple. See Fig 1 .
    Fig 1: Testing Check and Cut Valve (GLC) Hold valve horizontally during test.
    G34046
  2. Blow through open end of "T" fitting. When pressure gauge reads .78-1.0 psi (.06-.07 kg/cm2 ), valve should open.
  3. Remove "T" fitting and gauge from fuel tank nipple, and connect to nipple at bottom of valve (atmosphere vent). Hold valve horizontally.
  4. Repeat test. Valve should open when pressure gauge reads .14-.71 psi (.01-.05 kg/cm2 ). If valve does not operate as described, replace check and cut valve.
scientia non olet · About Brad's Car Manuals