Power Cut Switch
Disconnect main switch connector. Check continuity across specified terminals of main switch connector with power cut switch button held in specified position. See POWER CUT SWITCH CONTINUITY TEST table. See Figure . Replace main switch if continuity is not as specified.
POWER CUT SWITCH CONTINUITY TEST
| Switch Position | Terminals (1) | Continuity | |||
|---|---|---|---|---|---|
| Passenger | |||||
| ON | H, J & I | Yes | |||
| OFF | J & I | Yes | |||
| Right Rear | |||||
| ON | C, E & H | Yes | |||
| OFF | C & E | Yes | |||
| Left Rear | |||||
| ON | H, I & K | Yes | |||
| OFF | I & K | Yes | |||
|
|||||