Ignition Timing: Testing and Inspection

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

1. Start the engine and run it at idle.
2. Warm up the engine to normal operating temperature.

3. Connect the SSTs (NGS tester) to the DLC-2.
4. Select the PID/DATA MONITOR AND RECORD function on the NGS display.
5. Select the IGT PID.
6. Verify that IGT PID is within the specification.

Specification
BTDC 4° - 16° (10° ± 6°)

7. Increase the engine speed and verify that the IGT PID value is increased.
- If it is not increased inspect the following.
- CKP sensor and related harness
- MAF sensor and related harness