Using SST (WDS or Equivalent): Procedure
NOTE:
- PIDs for the following parts are not available on this model. Go to the appropriate part inspection page.
- ECT sensor (Water temperature sender unit). (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION .)
- Camshaft position sensor. (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION .)
- Main relay. (See RELAY INSPECTION .)
- Connect the WDS or equivalent to the DLC-2.
- Turn the ignition switch to the ON position.
- Measure the value.
- If value is not within the specification, follow the instructions in ACTION column.