Relay Box: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

PASSENGER JUNCTION BOX (PJB) REMOVAL/INSTALLATION
1. When replacing the PJB, perform the following:
- PJB configuration

2. Disconnect the negative battery cable.
3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

Connector A Removal Note

1. Push the release tab in the direction of the arrow.
2. Rotate the lever in the direction of the arrow and remove connector A.

Connector B Removal Note

1. Rotate the lever in the direction of the arrow and remove connector B.

PJB Removal Note

1. Turn the screws counterclockwise to remove the PJB.

NOTE: Screws cannot be removed from the PJB

2. Remove the PJB as shown in the figure.

Connector B Installation Note
1. Install the connector B as shown in the figure.

Connector A Installation Note

1. After connecting the connector, rotate the lever in the direction of the arrow to install connector A.