Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Mazda >> 2008 >> 3 Mazdaspeed, 2.3 M >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System >> Steering Angle Sensor Inspection

Steering Angle Sensor Inspection

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Remove the column cover.
  2. Turn the ignition switch to the ON position and measure the voltage between steering angle sensor terminal A and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal A and DSC HU/CM terminal AB. Repair or replace if necessary.

    Standard voltage B+ 

  3. Measure the voltage between steering angle sensor terminal D and ground.
    • If there is any malfunction, inspect the wiring harness between steering angle sensor terminal D and DSC HU/CM terminal AH. Repair or replace if necessary.
      Fig 1: Identifying Steering Angle Sensor Connector Terminals
      G04955752Courtesy of MAZDA MOTORS CORP.

    Standard voltage 0V 

  4. Turn the ignition switch off.
  5. Connect the M-MDS to the DLC-2.
  6. Select the "SWA_POS" PID.
  7. Verify the SWA_POS changes when the steering wheel is turned to the left and right.
    • If there is any malfunction, replace the steering angle sensor. (See CLOCK SPRING REMOVAL/INSTALLATION .)
      Fig 2: Identifying DLC-2 Connector
      G04955753Courtesy of MAZDA MOTORS CORP.

    Standard When the steering wheel is turned to the left: SWA_POS changes positively. 

    When the steering wheel is turned to the right: SWA_POS changes negatively.