Filament Repair
- Clean the filament using isopropyl alcohol.
- Attach tape to both sides of the filament.
- Using a small brush or marking pen, apply silver paint.
- After 2-3 min
., carefully remove the tape without damaging the applied area.
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- Do not operate the rear window defroster until the paint is completely dry. It may cause other malfunctions if it is used before the paint is dry.
- Dry the repaired part according to the following procedure.
- When the room temperature is 25 °C {77 °F}
, leave it as it is for 24 h
.
- When a hot air blower is used, dry with the 150 °C {302 °F}
air for 30 min
.