Barometric Pressure Sensor: Testing and Inspection

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [13B-MSP]

NOTE:
- Before performing the following inspection, make sure to follow the troubleshooting flowchart. Initial Inspection and Diagnostic Overview

1. Connect the M-MDS to the DLC-2.

2. Turn the ignition switch to the ON position.

3. Select BARO on the M-MDS.

4. Verify that the BARO PID voltage is within the specification.

- If not as verified, replace the PCM. Service and Repair

BARO Sensor Output Voltage
- 2.44-3.80 V