Service Cautions: Reassembly

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.

Fig 1: Tightening Drive Plate Bolts
Courtesy of MAZDA MOTORS CORP.

If removed, these parts should be replaced with new ones:

Oil seals	Cotter pins
Gaskets	Locknuts (Nylon nuts)
O-rings	Spring pins
Lock washers	-

Depending on location:
- Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
- Oil should be applied to the moving components of parts.
- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.
  
  Fig 2: Identifying Sealant Application Area
  Courtesy of MAZDA MOTORS CORP.