Filament Repair
- Clean the filaments using isopropyl alcohol.
- Affix tape along both sides of the filament to be repaired.
- Apply commercially available silver paint using a fine-tipped tool such as a small brush or a drawing pen.
- After 2-3 min, peel off the tape being careful not to damage the painted area.CAUTION:
- Do not operate the rear window defroster until the repaired area is completely dried to prevent a malfunction.
- Completely dry the repaired area referring the following:
- If the room temperature is 25°C {77°F}, leave it for 24 h.
- When using a hot air blower, dry for 30 min at 150°C {302°F}.