Barometric Pressure (BARO) Sensor Inspection

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

NOTE:

The BARO sensor cannot be removed as a single unit. When replacing the BARO sensor, replace it together with the PCM as a single unit.

Connect the M-MDS to the DLC-2.
Switch the ignition to ON.
Verify that the BARO sensor output voltage (PID: BARO) within the specification. (See ON-BOARD DIAGNOSTIC TEST .) (See PCM INSPECTION .)
- If not as specified, replace the PCM. (See PCM REMOVAL/INSTALLATION .)