Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Mitsubishi >> 1985 >> Galant >> Repair and Diagnosis >> Engine Performance >> System >> ECI CEC System >> Component Testing >> Control Relay

Control Relay

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Control relay is mounted on top of ECU. Disconnect electrical harness and test continuity between terminals "1" and "7", then "3" and "7". If there is no continuity, relay is good. If continuity is measured, replace control relay.
  2. Apply 12 volts across terminals "8" (positive) and "4" (negative) while testing continuity between terminals "3" and "7". If continuity is measured, relay is good. If not, replace relay.
  3. Apply 12 volts across terminals "6" (positive) and "4" (negative) while testing continuity between terminals "1" and "7". If there is continuity, relay is good. If not, replace relay.
  4. Apply 12 volts across terminals "5" (positive) and "2" (negative) while testing continuity between terminals "1" and "7". If there is continuity, relay is good. If not, replace relay.
scientia non olet · About Brad's Car Manuals