Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Nissan-Datsun >> 1989 >> Sentra Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Remove/Install/Overhaul >> Distributor >> Installation

Remove, Overhaul & Install: Remove/Install/Overhaul: Distributor: Installation

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches

To install, reverse removal procedure. Ensure marks or indententions on distributor shaft and housing are aligned. Check or replace rubber "O" ring seal. After installing distributor, confirm distributor rotor is lined up with mark made during removal or set at No. 1 cylinder spark plug position. Check and adjust timing. See D - 4-CYL ADJUSTMENTS or D - V6 ADJUSTMENTS section. Tighten distributor hold-down bolt as specified. See DISTRIBUTOR HOLD-DOWN BOLT TORQUE SPECIFICATION table in this article.

DISTRIBUTOR HOLD-DOWN BOLT TORQUE SPECIFICATION

Application INCH lbs. (N.m)
Maxima 120-144 (13.6-16.3)
Pathfinder & Pickup
4-Cylinder 36-72 (4.1-8.1)
V6 43-52 (4.9-5.9)
Pulsar NX XE 84-108 (9.5-12.2)
Sentra 84-108 (9.5-12.2)
Stanza 144-168 (16.3-19.0)
240SX 84-108 (9.5-12.2)
300ZX 48-60 (5.4-6.8)