Delay Timer Function

• When ignition switch ON and ACC are OFF while auto light switch is ON, BCM turn on/off headlamp. In delay timer function, auto light sensor power source is OFF and BCM is not turned on/off by auto light sensor signal. On condition that:
• when the states ignition switch ON or ACC is ON and output judgment by auto light function is headlamp ON turn to ignition switch ON or ACC are OFF and door switch (driver side), door switch (passenger side), rear door switch (right side), rear door switch (lift side) and back door switch is ON, output judgment by auto light function should be headlamp ON for 5 minutes by timer. After time out, output judgment by auto light function should be headlamp OFF.
• when the state is door switch (driver side), door switch (passenger side), rear door switch (right side), rear door switch (lift side) and back door switch are OFF 45 seconds or 5 minutes while timer is counting, timer stops, and re-start counting for 5 minutes, then auto light function judges output as headlamp ON. After time out, auto light function judges output as headlamp OFF.
• when the states door witch (driver side), door switch (passenger side), rear door switch (right side), rear door switch (lift side) and back door switch are ON turns to door switch (driver side), front door switch (passenger side), rear door switch (right side), rear door switch (lift side) and back door switch are OFF 45 seconds or 5 minute timer while is counting, Timer stops, and re-start counting for 45 seconds, then auto light function judges output as head lamp ON. After timer out and auto light function judges output as head lamp OFF.
• when the state is ignition switch ON or ACC is ON or auto light switch OFF while timer is counting, timer stops counting and BCM turns on/off lamps according to headlamp function, front fog lamp function, auto light function and headlamp battery save function.

Delay timer control mode can be changed by the function setting of CONSULT-II.