CONSULT-II Reference Value in Data Monitor Mode

Remarks:

• Specification data are reference values.
• Specification data are output/input values which are detected or supplied by the ECM at the connector.

  * Specification data may not be directly related to their components signals/values/operations.

  (i.e., Adjust ignition timing with a timing light before monitoring IGN TIMING. Specification data might be displayed even when ignition timing is not adjusted to specification. This IGN TIMING monitors the data calculated by the ECM according to the input signals from the camshaft position sensor and other ignition timing related sensors.)

  Fig 1: Consult-II Reference Value In Data Monitor Mode Chart (1 Of 2)

  Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Consult-II Reference Value In Data Monitor Mode Chart (2 Of 2)

Courtesy of NISSAN MOTOR CO., U.S.A.