Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Nissan-Datsun >> 2021 >> Kicks S >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Steering Control System >> Basic Inspection >> Additional Service When Replacing Control Module >> Work Procedure

Work Procedure

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. SAVING EPS CONTROL UNIT DATA (VEHICLE SPECIFICATIONS) 
    NOTE: Save necessary data stored in EPS control unit in CONSULT according to the following instructions:

    SYMBOL CONSULT

    1. Ignition switch OFF.
    2. Ignition switch ON.
    3. Select "Re/programming, Configuration".
    4. Select "EPS/DAST 3".
      NOTE: If "EPS/DAST 3" is not displayed and EPS control unit data cannot be saved on CONSULT, GO TO 3.
    5. Select "Programming".
    6. Save EPS control unit data on CONSULT according to the CONSULT display.

    GO TO 2.

  2. REPLACE EPS CONTROL UNIT 
    1. Ignition switch OFF and wait for 10 seconds.
    2. Replace EPS control unit. Refer to Removal and Installation .

    GO TO 3.

  3. WRITE EPS CONTROL UNIT DATA (VEHICLE SPECIFICATIONS) 
    NOTE: Write data saved in CONSULT into a new EPS control unit according to the following instructions:

    SYMBOL CONSULT

    1. Select "Programming".
    2. Perform programming according to the CONSULT display.

    Inspection End.

scientia non olet · About Brad's Car Manuals