Air Flow Meter/Sensor: Service and Repair

Removal
1. Move convertible top or convertible top compartment lid to service position.
2. Remove linings for convertible top rest and engine compartment lid.
3. Pull off electrical plug connection on the mass air flow sensor.







4. Undo oval-head screws with a commercially available Torx T 20 tool (with a bore in the drive tip).







Installation
1. Fit mass air flow sensor with seal and fasten with 5.0 x 20 oval-head screws.
Tightening torque 3 - 4 Nm (2.0 - 3.0 ft. lbs.)
2. Check whether a seal is present and the sensor is seated correctly. Fit plug.
3. Fit lining and engine compartment lid.