OBD (II) - Diagnostic Introduction, Fault Code Index

• OBD (II)
  • Introduction
    • General
      • Notes
      • Digital engine control module DME 7.1.1
      • Note on adaption
      • Standardized fault codes according to ISO 15031
    • Definition of terms
      • Warm-up cycle
      • Driving cycle
      • Ready status
      • Freeze frames (officially prescribed 'frozen fault boundary conditions')
      • Other ambient conditions
      • Fault shedding (confirmation of a suspected fault)
      • Fault healing (CE light off)
      • Fault erasing counter
      • Fault frequency counter
    • Warnings
      • Warnings
    • Notes on troubleshooting
      • Working on oxygen sensors
    • Troubleshooting procedure
    • Diagnosis conditions
      • Notes
      • Possible fault causes
      • Faulty DME
    • Diagnosis/troubleshooting
      • Notes
      • Fault type
      • Fault status
      • End of troubleshooting (→ End)
• Tools for DME 7.1.1 troubleshooting
  • Notes
  • Battery charging device
  • 9588 Porsche System Tester II
  • Digital multimeter
  • 9684 Set of measuring aids
  • 173 Universal test box, 105-pole
  • 173-1 Adapter cable, DME 7.1.1
  • 9160/1 Tester
• Component arrangement
  • About the views
  • Cayenne V8S and V8 Turbo
    • V8 turbo engine, top view
    • V8 turbo engine, front view
    • V8 turbo engine, rear view
    • V8 S and turbo engine, underside view
    • Oxygen sensing, V8 S and turbo
    • Charge measurement and fuel supply of V8S
    • Charge measurement and fuel supply - additional components, turbo
    • Camshaft adjustment and ignition with sensors, V8S and turbo
    • Temperature control with sensors, V8S and turbo
    • Tank leak test - USA vehicles only
    • Power supply
  • Cayenne V6
    • Engine, front view
    • Engine, rear view
• Connector pin assignment of DME7.1.1
  • Control module and connectors
  • Connector assignment - Cayenne V8
    • Connector A on control module DME 7.1.1 - 81 - pole
    • Connector B on control module DME 7.1.1 - 40-pole
  • Connector assignment - Cayenne V6
    • Connector A on control module DME 7.1.1 - 81 - pole
    • Connector B on control module DME 7.1.1 - 40-pole
• Fault overview
  • Notes
  • Fault overview for V8 & V8 Turbo
  • Fault overview for Cayenne V6
• Unnecessary DME 7.1.1 control module replacement
  • Notes
  • Overview table of P-codes for which the DME control module cannot be the cause
• Fault Code Index