Blower Motor Control Processor Replacement

Download the full database via torrent (~1.1 TB)

Blower Motor Control Processor Replacement

Removal Procedure

1. Remove the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Instrument Panel Insulator Panel Replacement - Right Side).
2. Disconnect the electrical connector from the blower motor.

3. Disconnect the electrical connector (3) from the blower motor control processor (1).
4. Remove the blower motor control processor mounting screws (2).
5. Remove the blower motor control processor (1).

Installation Procedure

1. Install the blower motor control processor (1).

Notice: Refer to Fastener Notice.

2. Install the blower motor control processor mounting screws (2).

Tighten the screws to 1.9 Nm (17 in. lbs.).

3. Connect the electrical connector (3) to the blower motor control processor (1).
4. Connect the electrical connector to the blower motor.
5. Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Instrument Panel Insulator Panel Replacement - Right Side).