Power Mirror Motor

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Remove power mirror trim panel screw. Loosen Allen set screw. Remove trim panel. Remove foam filler from door frame. Disconnect harness connector. Using jumper wires, connect specified terminals. See Figure . See POWER MIRROR MOTOR TEST table. Observe power mirror for correct movement. If mirror does not respond as specified, replace power mirror motor.

POWER MIRROR MOTOR TEST

Apply 12 Volts To Pin	Ground Pin	Mirror Operation
1	2	Up
2	1	Down
2	3	Left
3	2	Right