Accelerator Pedal Position Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Accelerator Pedal with Position Sensor Assembly Replacement

Removal Procedure

1. Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Service and Repair).
2. Disconnect the instrument panel wiring harness electrical connector (2) from the accelerator pedal position (APP) sensor (1).

3. Remove the APP sensor bolts (1).
4. Remove the APP sensor (2).

Installation Procedure

1. Position the APP sensor (2) against the brake pedal assembly.

Caution: Refer to Fastener Caution (Fastener Caution)

2. Install the APP sensor bolts (1) and tighten to 10 Nm (89 lb in).

3. Connect the instrument panel wiring harness electrical connector (2) to the APP sensor (1).
4. Install the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Service and Repair).