Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Scion >> 2005 >> xA Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Starting & Charging >> Generator ASSY >> Replacement

Generator ASSY: Replacement

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. REMOVE GENERATOR ASSY 
    1. Remove the terminal cap.
    2. Remove the nut and generator wire.
    3. Disconnect the generator connector.
    4. Remove the wire harness clamp.
      Fig 1: Removing Generator Assy
      G03195407Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Loosen bolts A and B.
    6. Release the fan and generator V-ribbed belt tension, and remove the fan and generator V-ribbed belt.
      Fig 2: Loosening Bolts A & B
      G03195408Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Remove bolt A and the nut, then remove the fan belt adjusting bar.
      Fig 3: Identifying Fan Belt Adjusting Bar Removing Bolt & Nut
      G03195409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Remove bolt B and the generator.
      Fig 4: Removing Bolt B
      G03195410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL GENERATOR ASSY 
    1. Temporarily install the generator with bolt B.
      Fig 5: Installing Generator With Bolt B
      G03195411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Temporarily install the fan belt adjusting bar with bolt A, and tighten the nut to the specified torque.

      Torque: 11 N.m (112 kgf.cm, 8 ft.lbf) 

      Fig 6: Installing Fan Belt Adjusting Bar Bolt & Nut
      G03195412Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Temporarily install the fan and generator V-ribbed belt onto each pulley.
    4. Insert the adjusting bar between the engine mounting bracket and generator. Push the adjusting bar towards the vehicle front to adjust the V-ribbed belt tension.
      NOTE: Do not insert the adjusting bar between the oil control valve and generator because it could damage the oil control valve.
      Fig 7: Precautions For Inserting Adjusting Bar Between Oil Control Valve & Generator
      G03195413Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. First tighten bolt A, then tighten bolt B.

      Torque: 

      19 N.m (189 kgf.cm, 14 ft.lbf) for bolt A 

      54 N.m (551 kgf.cm, 40 ft.lbf) for bolt B 

    6. Install the wire harness clamp.
    7. Connect the generator connector.
    8. Install the generator wire with the nut.

      Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf) 

    9. Install the terminal cap.
  3. INSPECT DRIVE BELT (See  INSPECTION  )