Throttle Position Sensor/Switch

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

NOTE: All testing procedures are performed with engine at normal operating temperature.

Turn ignition on. With throttle fully closed, measure and record voltage to ground at specified ECM terminals. Open throttle fully. Repeat voltage measurements. See TPS VOLTAGE SPECIFICATIONS table.

TPS VOLTAGE SPECIFICATIONS

Throttle Position & Terminal No.		Voltage
Throttle Closed
4		0.4-0.5
11		0
15		4.4-5.5
Throttle Open
4		3.5-4.3
11		0
15		4.4-5.5

If necessary, loosen retaining screws and rotate TPS until correct voltages are obtained. Replace TPS if voltage cannot be adjusted to specification.