Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Subaru >> 2002 >> Impreza RS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> A/T Control Systems >> Select Cable >> Removal

Select Cable: Removal

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Set the vehicle on the lift.
  2. Disconnect the ground terminal from battery.
  3. Prior to removal, set the lever to "N" position.
  4. Lift-up the vehicle.
  5. Remove the front and center exhaust pipe. (Non-turbo model) < Ref. to REMOVAL , Front Exhaust Pipe. >
    CAUTION: When removing the exhaust pipes, be careful each exhaust pipe does not drop out.
  6. Remove the center exhaust pipe. (Turbo model) < Ref. to REMOVAL , Center Exhaust Pipe. >
  7. Remove the heat shield cover. (If equipped)
  8. Remove the snap pin from range select lever.
    Fig 1: Removing Snap Pin From Range Select Lever
    G02871531Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the plate assembly from transmission case.
    Fig 2: Removing Plate Assembly From Transmission Case
    G02871532Courtesy of SUBARU OF AMERICA, INC.
  10. Disconnect the cable from select lever and then remove the cable bracket.
    Fig 3: Disconnecting Cable From Select Lever And Removing Cable Bracket
    G02871533Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
scientia non olet · About Brad's Car Manuals