Control Valve Body: Installation

Check the control valve body for dust and other foreign matter.
Install the control valve body to transmission by equally tightening the bolts.
Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Identifying Control Valve Body Bolts
Courtesy of SUBARU OF AMERICA, INC.
Connect the control valve connector.

Fig 2: Disconnecting/Connecting Control Valve Connector And Front Vehicle Speed Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Attach the magnet at the specified position of the oil pan.

Fig 3: Identifying Magnet
Courtesy of SUBARU OF AMERICA, INC.
Apply liquid gasket to the oil pan.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)

Fig 4: Applying Liquid Gasket To Oil Pan
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan by equally tightening the bolts.
Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb)
Pour ATF through the oil charge pipe.
Specified and recommended fluid: < Refer to RECOMMENDED GEAR OIL , SPECIFICATION, GENERAL DESCRIPTION. >

Capacity: Fill with the same amount of ATF as drained.
Check the ATF level.
< Refer to AUTOMATIC TRANSMISSION FLUID . >
Perform Clear Memory 2 operation. < Refer to CLEAR MEMORY MODE , OPERATION, Subaru Select Monitor. >
Perform the inspection with driving the vehicle at the end of repair work, and make sure there is no faulty as below;

NOTE: If excessive shift shock is felt, execute advance operation of learning control. < Refer to PROCEDURE , Learning Control. >