Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Subaru >> 2012 >> Outback Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Speed Control Systems (H4SO) >> Accelerator Pedal >> Inspection >> Check Accelerator Pedal Sensor Area (Method With Circuit Tester)

Check Accelerator Pedal Sensor Area (Method With Circuit Tester)

Download the full database via torrent (~1.1 TB)
  1. Remove the glove box lid assembly, glove box lower cover, instrument panel side cover RH and glove box back panel. Refer to GLOVE BOX .
  2. Turn the ignition switch to ON. (engine OFF)
  3. Measure the voltage between ECM connector terminals.
    Fig 1: Locating Glove Box Lid Assembly
    G06648245Courtesy of SUBARU OF AMERICA, INC.

    Main sensor side

    Fig 2: Measuring Voltage Between ECM Connector Terminals (Main Sensor Side)
    G06648606Courtesy of SUBARU OF AMERICA, INC.

    Sub sensor side

    Fig 3: Measuring Voltage Between ECM Connector Terminals (Sub Sensor Side)
    G07910024Courtesy of SUBARU OF AMERICA, INC.
    Accelerator pedal sensor Accelerator pedal Terminal No. Standard
    Main Not depressed (Full closed) 23 (+) and 29 (-) 1 V
    Depressed (Full opened) 3.5 V
    Sub Not depressed (Full closed) 31 (+) and 30 (-) 1 V
    Depressed (Full opened) 3.5 V
  4. After inspection, install the related parts in the reverse order of removal.
scientia non olet · About Brad's Car Manuals