Select Cable: Removal

Shift the select lever to "N" range.
Disconnect the ground cable from battery.
Lift up the vehicle.
Remove the front exhaust pipe and rear exhaust pipe.
- 2.5 L model
  Refer to REMOVAL , Front Exhaust Pipe. and REMOVAL , Rear Exhaust Pipe.
- 3.6 L model
  Refer to REMOVAL , Front Exhaust Pipe. and REMOVAL , Rear Exhaust Pipe.
Remove the heat shield cover.

Fig 1: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the snap pin and washer from the shifter arm and remove the select cable from the shifter arm.
- CVT model
  
  Fig 2: Identifying Shifter Arm, Snap Pin, Select Cable, Plate Assembly And Washer (CVT Model)
  Courtesy of SUBARU OF AMERICA, INC.
- AT model
  
  Fig 3: Identifying Shifter Arm, Snap Pin, Select Cable, Plate Assembly And Washer (AT Model)
  Courtesy of SUBARU OF AMERICA, INC.
Remove the plate assembly from the transmission case.
- CVT model
  
  Fig 4: Identifying Select Cable And Plate Assembly (CVT Model)
  Courtesy of SUBARU OF AMERICA, INC.
- AT model
  
  Fig 5: Identifying Select Cable And Plate Assembly (AT Model)
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the cable from arm assembly.

Fig 6: Identifying Arm Assembly And Nut
Courtesy of SUBARU OF AMERICA, INC.
Raise the claw of clamp to remove the cable from bracket.

Fig 7: Identifying Clamp Claw
Courtesy of SUBARU OF AMERICA, INC.
Remove the select cable from plate assembly.