Intake Manifold: Assembly

Connect the PCV hose and vacuum control hose to intake manifold.
Connect the vacuum hose to the intake manifold, and install the purge control solenoid valve.
Tightening torque:

19 N.m (1.9 kgf-m, 14.0 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the throttle body to the intake manifold.
NOTE: Use a new gasket.

Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Temporarily install the EGR pipe to the intake manifold.
NOTE:
- Use new O-rings.
- Tighten the EGR pipe when installing the intake manifold. Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (W/O STI)>EGR PIPE>INSTALLATION .
Courtesy of SUBARU OF AMERICA, INC.
Install the manifold absolute pressure & intake air temperature sensor to the intake manifold.
NOTE: Use new O-rings.

Tightening torque:

3.5 N.m (0.3 kgf-m, 2.5 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.