Underhood Inspection
NOTE:
This inspection is very important and must be done carefully and thoroughly.
Perform a careful underhood inspection when performing any diagnostic procedure or diagnosing the cause of an emission test failure. This can often lead to repairing a condition without further steps. Use the following guidelines when performing an inspection:
- Inspect all of the vacuum hoses for correct routing, pinches, cuts, or disconnects.
- Inspect any hoses that are difficult to see.
- Inspect all of the wires in the engine compartment for the following conditions:
- Burned or chafed spots
- Pinched wires
- Contact with sharp edges
- Contact with hot exhaust manifolds