Additional Service When Replacing Control Unit
Additional Service When Replacing Control UnitDescription
When replacing BCM, save or print current vehicle specification with SDT configuration before replacement. Configuration has three functions as follows
- READ CONFIGURATION is the function to read (extract) vehicle configuration of current BCM.
- WRITE CONFIGURATION - Manual selection is the function to select and write vehicle configuration on BCM ly.
- WRITE CONFIGURATION - Config file is the function to write vehicle configuration with the data extracted from current BCM.
CAUTION:
- When replacing BCM, you must perform WRITE CONFIGURATION with SDT.
- Complete the procedure of WRITE CONFIGURATION in order.
- If you set incorrect WRITE CONFIGURATION, incidents will occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Special Repair Requirement
