Body Control Module: Testing and Inspection
Additional Service When Replacing Control UnitDescription
When replacing BCM, save or print current vehicle specification with SDT configuration before replacement.
Configuration has three functions as follows
- READ CONFIGURATION is the function to read (extract) vehicle configuration of current BCM.
- WRITE CONFIGURATION - Manual setting is the function to select and write vehicle configuration on BCM manually.
- WRITE CONFIGURATION - Config file is the function to write vehicle configuration with the data extracted from current BCM.
CAUTION:
- When replacing BCM, you must perform WRITE CONFIGURATION with SDT.
- Complete the procedure of WRITE CONFIGURATION in order.
- If you set incorrect WRITE CONFIGURATION, incidents will occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Special Repair Requirement
