Charging System - Generators & Regulators: Generator: Removal

1. Disconnect the connector from the generator.
2. Remove the nut and disconnect the wire from the generator.

Loosen the adjust lock nut, adjusting bolt and pivot bolt, and remove the drive belt.

Fig 1: Removing Generator Drive Belt

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the pivot bolt and adjusting lock nut.
   Fig 2: Removing Generator Pivot Bolt & Adjusting Lock Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the generator.
   • Torque: 
   • Pivot bolt: 51 N.m (520kgf.cm, 38 ft.lbf) 
   • Lock Nut: 18.5 N.m (189kgf.cm, 25 ft.lbf)