Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Toyota >> 2006 >> Sequoia Limited, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control System >> Engine Coolant Temperature Sensor >> Inspection

Engine Coolant Temperature Sensor: Inspection

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. DRAIN ENGINE COOLANT 
  2. REMOVE THROTTLE BODY COVER 
  3. REMOVE INTAKE AIR CONNECTOR 
  4. DISCONNECT THROTTLE BODY FROM INTAKE MANIFOLDS 
    1. Remove the nut and 3 bolts, and disconnect the throttle body from the intake manifold.
  5. REMOVE ECT SENSOR 
    1. Disconnect the ECT sensor connector.
    2. Remove the ECT sensor and gasket.
      Fig 1: Removing ECT Sensor
      G04507031Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSPECT ECT SENSOR 
    1. Using an ohmmeter, measure the resistance between the terminals.

      Resistance: Refer to the  

      If the resistance is not as specified, replace the ECT sensor.

  7. REINSTALL ECT SENSOR 
    1. Install a new gasket and the ECT sensor.

      Torque: 19.6 N*m (200 kgf*cm, 14 ft.*lbf) 

    2. Connect the ECT sensor connector.
  8. REINSTALL THROTTLE BODY TO INTAKE MANIFOLDS 
    1. Install a new gasket and the throttle body with the 2 bolts and 2 nuts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

  9. REINSTALL INTAKE AIR CONNECTOR 
  10. REFILL WITH ENGINE COOLANT 

    (See REPLACEMENT )

    Fig 2: Measuring Resistance Between ECT Sensor Terminals
    G04507032Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REINSTALL THROTTLE BODY COVER