Rear Wheel Alignment: Inspection

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

INSPECT TIRE
1. Inspect the tires (see TIRE AND WHEEL SYSTEM ).
MEASURE VEHICLE HEIGHT
1. Measure the vehicle height (see ADJUSTMENT ).

INSPECT TOE-IN

Standard toe-in

SPECIFIED CONDITION CHART

Item	Specified Condition
Toe-in (total)	A + B: 0° 18' +-15' (0.30° +-0.25°) C - D: 3.0 +-2.5 mm (0.12 +-0.10 in.)

HINT:

Measure "C - D" only when "A + B'" cannot be measured.
If the toe-in is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.

Fig 1: Measuring Wheel Alignment

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT CAMBER

Install the camber-caster-kingpin gauge or set the vehicle on a wheel alignment tester.

Inspect the camber.

Standard camber

SPECIFIED CONDITION CHART

Item	Specified Condition
Camber Right-left error	-1° 30' +-30' (-1.50 +-0.5°) 30' (0.5°) or less

HINT:

Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.