Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Toyota >> 2009 >> Sienna CE >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column Assembly >> Disassembly

Steering Column Assembly: Disassembly

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY 
    1. Align the matchmarks on the steering intermediate shaft assembly and main shaft.
    2. Remove the bolt and steering intermediate shaft assembly.
    Fig 1: Aligning Matchmarks On Steering Intermediate Shaft Assembly And Main Shaft
    G05140351Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System) 
  3. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) 
    1. Widen the claw hanging onto the upper bracket by approx. 1.0 mm (0.039 in.) using a screwdriver.
    2. Pull the transponder key amplifier toward the rear of the vehicle with the claw open.
      NOTE: Take care not to use excessive force to prevent the case from being damaged.
      Fig 2: Pulling Transponder Key Amplifier
      G05140352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE STEERING COLUMN BRACKET ASSEMBLY UPPER 
    1. Using a centering punch, mark the center of the 2 tapered-head bolts.
    2. Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole into the heads of the 2 bolts.
    3. Using a screw extractor, remove the 2 bolts and steering column upper w/ switch bracket assembly.
      Fig 3: Removing Bolts And Steering Column Upper W/ Switch Bracket Assembly
      G05140353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY 
    1. Place the ignition switch lock cylinder assembly in the ACC position.
    2. Push down the stop pin with a screwdriver, and pull out the cylinder assembly.
      Fig 4: Pulling Out Cylinder Assembly
      G05140354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY 
    1. Disconnect the un-lock warning switch assembly connector from the ignition or starter switch assembly.
    2. Remove the un-lock warning switch assembly by pushing up the center part and releasing the 2 claws.
      Fig 5: Removing Un-Lock Warning Switch Assembly
      G05140355Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the secondary locking device.
    4. Using a screwdriver, disengage the locking lug of terminals 1 and 2, and pull the terminals out from the rear side of the un-lock warning switch assembly.
    Fig 6: Removing Screws And Solenoid From Steering Column Bracket Assembly
    G05140356Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE KEY INTER LOCK SOLENOID 
    1. Remove the 2 screws and solenoid from the steering column bracket assembly.
  8. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY 
    1. Remove the 2 screws and ignition or starter switch assembly from the steering column bracket assembly UPR.