Gearbox Aw55-50 - Installation
- Transmission
- Installing the gearbox
- Notes
- Installation
- Notes
- Installing the gearbox
- Installing and tightening the screws to the gearbox
- Fitting the torque converter screws.
- Lifting the engine/gearbox
- Installing the rear engine mounting
- Installing the angle gear
- Installing the lower oil pipe to the gearbox
- Installing the left-hand drive shaft to the gearbox and the wheel spindle
- Fitting the subframe to the body
- Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm
- Tightening the subframe screws (both sides)
- Fitting the screws for engine pads and the torque rod bracket in the gearbox
- Installing the steering wheel shaft joint
- Installing the collision protection system over the steering gear
- Installing the crossmembers
- Installing and tightening the front suspension components
- Installing the cable conduit
- Removing the lifting beam
- Installing the water hose
- Fitting the remaining screws to the gearbox/starter motor
- Installing the gear selector cables and oil line
- Installing service clips
- Installing engine compartment components
- Finishing
- Installing the gearbox